Before you start

  • You need User Management or Operation Management.

Steps

  1. Select your name at the bottom of the sidebar.

  2. Select System Settings.

  3. Under HVAC Calculator Default Factors, type the values you use. Leave a field empty to use the default shown in it.

    FieldRequiredWhat to enter
    Glass FactorNoDefault 0.56. At most 1.0.
    Wall FactorNoDefault 0.36.
    Roof FactorNoDefault 0.55.
    Partition / Ceiling / Floor FactorNoDefault 0.32.
    All Glass Partition FactorNoDefault 1.13.
    Selected ADPNoIn °C or °F by unit system. Used only when the ESHF solver cannot converge.
  4. Select Save Changes.

Result

The message "System settings saved" shows. "These values will be used as default factors in the HVAC calculator. You can override them per row on the calculator page."

If something is different

  • "Glass factor cannot exceed 1.0": enter 1.0 or less.
  • "Failed to save HVAC factors": try again.