A stage says "Awaiting system selection" or "Not applicable to selected system"
Pipe Sizing, Ductwork Planning and Ventilation depend on the project's system type. Why they are greyed out, marked not applicable or hidden, and what to do.
At a glance
Who can do it
Owner, Admin, Manager, Technician, User
Time
About 3 min
What you see
Pipe Sizing, Ductwork Planning or Ventilation & Fresh Air Planning is greyed out with "Awaiting system selection" and does not open.
A stage shows the badge "Not applicable to selected system". Its main task reads "Not applicable to the selected system. Any saved work on this stage stays available." Its tool button reads View saved work.
One of these stages has gone from the list.
Why it happens
"Awaiting system selection": these three stages depend on the project's system. For Ductwork Planning and Pipe Sizing, the stage waits until someone confirms the system on the System summary panel of AC Unit Recommendations; until then the app cannot tell whether the stage is needed.
"Not applicable to selected system": the chosen system does not need this stage, but the stage already holds work. The work is kept.
The stage has gone: the chosen system does not need it and it held no work, so it is hidden.
What to do
If the project has no system type yet, set System type under Load & System in Edit Project. See Edit a project. If a warning opens because stages would be affected, read it, then select Continue or Cancel.
Open the project's System Type Selection stage and select Open Recommendations.
On the System summary panel, answer any question and select Confirm system. See Confirm the project's system.
For a not-applicable stage, select View saved work to read what was saved before.
If it still happens
If the stage still reads "Awaiting system selection" after the system is confirmed, reload the project.