Before you start
- You need Inventory Management, and Edit on Projects to save a value.
- Open AC Unit Recommendations for the project. See Open AC Unit Recommendations for a project.
Steps
Set your own airflow
-
At the top of the results column, find Design airflow:. It shows "(from heat load)" or "(manual override)".
-
Select Edit, or Set manually when there is no value. In the footer the link reads Set design airflow manually.

Step 2. The Design airflow line being edited, in CFM. -
Type the airflow in CFM, digits only. While the value comes from heat load, the edit line shows only the field, "CFM" and Save.
-
Select Save, or press Enter. Escape cancels.
Go back to the heat load's airflow
- On the Design airflow: line, select reset. Or save 0 or a blank value. There is no reset while the value comes from heat load.
Result
Set your own airflow: the line reads "(manual override)". The airflow verdict in the footer uses it.
Go back to the heat load's airflow: the line reads "(from heat load)" again.
If something is different
- "Could not save the airflow override": you may not have Edit on Projects. Try again, or ask your administrator.
- "run the heat load first.": calculate the project's heat load. See Calculate the heat load for a project.
- "the heat-load result carries no positive sensible load to distribute.": check the heat load's inputs and calculate again.
- A message about a supply temperature rise of zero or below: "usually a missing room dry-bulb temperature. Fix the design conditions and recalculate." See Change a space and calculate it again.
- "not applicable for heating-only": a heating-only project has no design airflow.
