What it is

Design conditions are the outdoor and indoor conditions a project's heat load is calculated for: dry bulb, wet bulb, humidity for summer, winter and monsoon, plus a few envelope values for the heat load engine. They are shown in the Design Conditions card on the project's Overview tab.

Every new space in the project starts with these conditions in its Conditions step: "Loaded from the project's design conditions. Adjust if the job spec differs."

How it moves

The badge on the card tells you where the values came from:

  1. Resolved: the values come from the weather station matched to the project's location.
  2. Edited: someone changed values with Edit values.
  3. Back to Resolved: Reset overrides returns to the station's values. Re-resolve from location matches the station again.
  4. No station nearby: no weather station covers the project's location.
  5. Fallback: no location: the project has no location to match a station from.

You can also pick a station yourself with Use this station, or Use [station] when a nearer station exists.

A space already saved keeps the conditions it was calculated with, even after the project's conditions change. See A space still uses the old design conditions.

Who is involved

RoleWhat they do
Anyone who can open the projectSees the design conditions and the badge.
Anyone with Edit on ProjectsEdits the values, re-resolves, resets, and chooses a station. Others see the buttons, but saving is refused.