The Design Conditions card
On the project's Overview tab. The card shows the badge (Resolved, Edited, No station nearby or Fallback: no location), the station line, then three sections. A blank value shows "Not set".
| Section | Rows |
|---|---|
| Summer (with the unit) | Outdoor dry bulb, Outdoor wet bulb, Outdoor humidity ratio, Indoor dry bulb, Indoor wet bulb, Indoor relative humidity |
| Winter | Outdoor dry bulb, outdoor wet bulb, indoor dry bulb, indoor relative humidity |
| Monsoon | Outdoor dry bulb, outdoor wet bulb, indoor dry bulb, indoor relative humidity |
| Envelope (heat load engine) | The envelope values below |
Below them: the station picker (Country, Station, Use this station) and the buttons Edit values, Re-resolve from location and Reset overrides (only after values were edited).
Edit design conditions: conditions
The box is titled "Edit design conditions (SI)" or "Edit design conditions (Imperial)". Each field shows its unit. Only the fields you change are saved.
| Season | Fields |
|---|---|
| Summer | Summer outdoor DB, Summer outdoor WB, Summer outdoor HR, Summer indoor DB, Summer indoor WB, Summer indoor RH |
| Winter | Winter outdoor DB, Winter outdoor WB, Winter indoor DB, Winter indoor RH |
| Monsoon | Monsoon outdoor DB, Monsoon outdoor WB, Monsoon indoor DB, Monsoon indoor RH |
Edit design conditions: Envelope compliance
| Field | Options |
|---|---|
| Climate zone | blank ("not set (no envelope flags)"), Hot and dry, Warm and humid, Composite, Temperate, Cold |
| Runs 24 hours | blank ("not answered (daytime limits apply)"), Yes, No |
The Envelope compliance flags switch on Modules & Firm Type exists, but no screen shows the flags yet.
Edit design conditions: Envelope (heat load engine)
| Field | Default or options |
|---|---|
| Coil bypass factor | 0.15 |
| Wall weight | 20, 60, 100 or 140 lb/sq ft. Default 100. |
| Roof weight | 10, 20, 40, 60 or 80. Default 40. |
| Daily range | °F. Default 20. |
| Site elevation | m. Blank means "assumed sea level". |
The buttons are Cancel and Save ("Saving…").
