Before you start
- You need Operation Management, and Add (for the first save) or Edit on Duct and load calculations.
- Duct Sizing is open from a project, and your company's plan is active. Without a project nothing is saved.
- Every duct has a Duct Name.
Steps
-
Watch the pill in the header bar: Saving…, Unsaved changes or All changes saved. Duct Sizing saves as you work.

Step 1. The header bar with Back, the project breadcrumb and the save pill. -
To save now, select Save at the bottom. It reads "Saving…" while it saves.
-
To leave, select Back. Duct Sizing saves first, then goes back.
Result
The message "Calculation saved successfully!" shows and the pill reads All changes saved. The sizing is stored with the project and linked to its Ductwork Planning stage.
If something is different
- "Couldn't save your changes automatically. Leave this page anyway?" when you select Back: see Changes may not be saved when I leave.
- A plan box opens when you save: see Save says the plan is not active, or Duct Sizing sends me to Billing.
- "Failed to save calculation": select Save again.
- "Project name is required.": open Duct Sizing from the project's Ductwork Planning stage.
- "Enter duct name.": a duct has no name. Fill in Duct Name.
- No Save button: Duct Sizing was opened without a project, or you have View only.
